|
Material Safety Data Sheet
for GL Sciences™ Bulk Silica Phases
GL Sciences’ Inc., Inertsil™ HPLC Chromatographic Silicas CAS# 7631-86-9
Synonyms:
None
CAS No.: 7631-86-9
Molecular Weight: Not available.
Chemical Formula: Not available.
Product Codes: , 0001 - 1365
2. Composition/Information on Ingredients
Ingredient CAS No Percent Hazardous
------------------------------------ ---------- ---------- ---------
Silica, Amorphous 7631-86-9 99 - 100% Yes
3.
Hazards Identification
Emergency Overview
--------------------------
CAUTION! MAY CAUSE IRRITATION TO SKIN, EYES, AND RESPIRATORY TRACT.
GL Sciences, Inc. Ratings (Provided here for your convenience)
-----------------------------------------------------------------------------------------------------------
Health Rating: 1 - Slight
Flammability Rating: 0 - None
Reactivity Rating: 0 - None
Contact Rating: 1 - Slight
Lab Protective Equip: GOGGLES; LAB COAT
Storage Color Code: Orange (General Storage)
-----------------------------------------------------------------------------------------------------------
Potential Health Effects
----------------------------------
This product contains synthetic amorphous silica, not to be confused with
crystalline silica such as quartz, cristobalite or tridymite or with
diatomaceous earth or other naturally occurring forms of amorphous silica
that frequently contain crystalline forms. NOTE: The hazard information
listed is for the material bonded to the flexible strip.
Inhalation:
May cause dryness and irritation to mucous membranes, nose, and throat.
Symptoms may include coughing, sore throat, and wheezing.
Ingestion:
No adverse effects expected.
Skin Contact:
May cause irritation with dryness and abrasion.
Eye Contact:
May cause irritation, redness and pain.
Chronic Exposure:
Repeated exposure may cause symptoms similar to those listed for acute
effects. Synthetic amorphous silica does not produce silicosis.
Aggravation of Pre-existing Conditions:
No information found.
4. First
Aid Measures
Inhalation:
Remove to fresh air. Get medical attention for any breathing difficulty.
Ingestion:
Give several glasses of water to drink to dilute. If large amounts were
swallowed, get medical advice.
Skin Contact:
Immediately flush skin with plenty of soap and water for at least 15
minutes. Remove contaminated clothing and shoes. Wash clothing before reuse.
Thoroughly clean shoes before reuse. Get medical attention if irritation
develops.
Eye Contact:
Immediately flush eyes with plenty of water for at least 15 minutes, lifting
upper and lower eyelids occasionally. Get medical attention if irritation
persists.
5. Fire
Fighting Measures
Fire:
Not considered to be a fire hazard.
Explosion:
Not considered to be an explosion hazard.
Fire Extinguishing Media:
Use any means suitable for extinguishing surrounding fire.
Special Information:
Use protective clothing and breathing equipment appropriate for the
surrounding fire.
6.
Accidental Release Measures
Ventilate area of leak or spill. Wear appropriate personal
protective equipment as specified in Section 8. Spills: Sweep up and
containerize for reclamation or disposal. Vacuuming or wet sweeping may be
used to avoid dust dispersal.
7. Handling and Storage
Keep in a tightly closed
container, stored in a cool, dry, ventilated area. Protect against physical
damage. Containers of this material may be hazardous when empty since they
retain product residues (dust, solids); observe all warnings and precautions
listed for the product.
8.
Exposure Controls/Personal Protection
Airborne Exposure Limits:
Silica (synthetic, amorphous):
- OSHA Permissible Exposure Limit (PEL) -
80/(%SiO2) mg/m3 (TWA) for amorphous silica, including natural diatomaceous
earth.
- ACGIH Threshold Limit Value (TLV) -
10 mg/m3 (TWA) for amorphous precipitated silica and amorphous silica gel.
Ventilation System:
A system of local and/or general exhaust is recommended to keep employee
exposures below the Airborne Exposure Limits. Local exhaust ventilation is
generally preferred because it can control the emissions of the contaminant
at its source, preventing dispersion of it into the general work area.
Please refer to the ACGIH document, Industrial Ventilation, A Manual of
Recommended Practices, most recent edition, for details.
Personal Respirators (NIOSH
Approved):
Not expected to require personal respirator usage. If the exposure limit is
exceeded and engineering controls are not feasible, a half facepiece
particulate respirator (NIOSH type N95 or better filters) may be worn for up
to ten times the exposure limit or the maximum use concentration specified
by the appropriate regulatory agency or respirator supplier, whichever is
lowest.. A full-face piece particulate respirator (NIOSH type N100 filters)
may be worn up to 50 times the exposure limit, or the maximum use
concentration specified by the appropriate regulatory agency, or respirator
supplier, whichever is lowest. If oil particles (e.g. lubricants, cutting
fluids, glycerine, etc.) are present, use a NIOSH type R or P filter. For
emergencies or instances where the exposure levels are not known, use a
full-facepiece positive-pressure, air-supplied respirator. WARNING:
Air-purifying respirators do not protect workers in oxygen-deficient
atmospheres.
Skin Protection:
Wear protective gloves and clean body-covering clothing.
Eye Protection:
Not expected to require eye protection. Maintain eye wash fountain and
quick-drench facilities in work area.
9.
Physical and Chemical Properties
Appearance:
White or off-white powder.
Odor:
Odorless.
Solubility:
Negligible (< 0.1%)
Specific Gravity:
No information found.
pH:
No information found.
% Volatiles by volume @ 21C (70F):
0
Boiling Point:
No information found.
Melting Point:
No information found.
Vapor Density (Air=1):
Not applicable.
Vapor Pressure (mm Hg):
Not applicable.
Evaporation Rate (BuAc=1):
No information found.
10.
Stability and Reactivity
Stability:
Stable under ordinary conditions of use and storage.
Hazardous Decomposition Products:
No information found.
Hazardous Polymerization:
Will not occur.
Incompatibilities:
Hydrogen fluoride, fluorine, xenon hexafluoride, oxygen difluoride, and
chlorine trifluoride. Substance can explode when wet and heated with
magnesium.
Conditions to Avoid:
Moisture, extreme heat, and incompatibles.
11.
Toxicological Information
Toxicological Data:
No LD50/LC50 information found relating to normal routes of occupational
exposure.
Carcinogenicity:
IARC category for silica, amorphous (7631-86-9) applies to silicas that may
contain crystalline silica. The silica in this product is synthetic and does
not contain crystalline silica.
--------\Cancer Lists\------------------------------------------------------
Ingredient Known Anticipated IARC Category
------------------------------------ ----- ----------- -------------
Silica, Amorphous (7631-86-9) No No 3
12.
Ecological Information
Environmental Fate:
No information found.
Environmental Toxicity:
No information found.
13.
Disposal Considerations
Whatever cannot be saved
for recovery or recycling should be managed in an appropriate and approved
waste disposal facility. Processing, use or contamination of this product
may change the waste management options. State and local disposal
regulations may differ from federal disposal regulations. Dispose of
container and unused contents in accordance with federal, state and local
requirements.
14.
Transport Information
Not regulated.
15.
Regulatory Information
--------\Chemical Inventory Status - Part 1\---------------------------------
Ingredient TSCA EC Japan Australia
----------------------------------------------- ---- --- ----- ---------
Silica, Amorphous (7631-86-9) Yes Yes Yes Yes
--------\Chemical Inventory Status - Part 2\---------------------------------
Ingredient Korea DSL NDSL Phil.
----------------------------------------------- ----- --- ---- -----
Silica, Amorphous (7631-86-9) Yes Yes No Yes
--------\Federal, State & International Regulations - Part 1\----------------
-SARA 302- ------SARA 313------
Ingredient RQ TPQ List Chemical Catg.
----------------------------------------- --- ----- ---- --------------
Silica, Amorphous (7631-86-9) No No No No
--------\Federal, State & International Regulations - Part 2\----------------
Ingredient CERCLA 261.33 8(d)
----------------------------------------- ------ ------ ------
Silica, Amorphous (7631-86-9) No No No
Chemical Weapons Convention: No TSCA 12(b): No CDTA: No
SARA 311/312: Acute: Yes Chronic: Yes Fire: No Pressure: No
Reactivity: No (Pure / Solid)
Australian Hazchem
Code: None allocated.
Poison Schedule: None allocated.
WHMIS:
This MSDS has been prepared according to the hazard criteria of the
Controlled Products Regulations (CPR) and the MSDS contains all of the
information required by the CPR.
16. Other
Information
NFPA Ratings:
Health: 1 Flammability: 0 Reactivity: 0
Label Hazard Warning:
CAUTION! MAY CAUSE IRRITATION TO SKIN, EYES, AND RESPIRATORY TRACT.
Label Precautions:
Avoid contact with eyes, skin and clothing.
Avoid breathing dust.
Keep container closed.
Use with adequate ventilation.
Wash thoroughly after handling.
Label First Aid:
If inhaled, remove to fresh air. Get medical attention for any breathing
difficulty. In case of contact, immediately flush eyes or skin with plenty
of water for at least 15 minutes. Get medical attention if irritation
develops or persists.
Product Use:
Laboratory Reagent.
Revision Information:
No Changes.
Disclaimer:
******************************************************************************************
GL Sciences, Inc. provides the information contained herein in good faith
but makes no representation as to its comprehensiveness or accuracy. This
document is intended only as a guide to the appropriate precautionary
handling of the material by a properly trained person using this product.
Individuals receiving the information must exercise their independent
judgment in determining its appropriateness for a particular purpose. GL
SCIENCES, INC. MAKES NO REPRESENTATIONS OR WARRANTIES, EITHER EXPRESS OR
IMPLIED, INCLUDING WITHOUT LIMITATION ANY WARRANTIES OF MERCHANTABILITY,
FITNESS FOR A PARTICULAR PURPOSE WITH RESPECT TO THE INFORMATION SET FORTH
HEREIN OR THE PRODUCT TO WHICH THE INFORMATION REFERS. ACCORDINGLY, GL
SCIENCES, INC. WILL NOT BE RESPONSIBLE FOR DAMAGES RESULTING FROM USE OF OR
RELIANCE UPON THIS INFORMATION.
******************************************************************************************
4733
Torrance, Blvd., Torrance, CA 90503, P (310)265-4424 F (310)265-4425
www.inertsil.com
www.glsciencesinc.com
info@inertsil.com |